Project: ____________________________________ Date: _______________
Measurements
| Input | Unit | Recorded value |
|---|---|---|
| Engraving width | mm | ________________ |
| Engraving height | mm | ________________ |
| Line spacing | mm | ________________ |
| Scan speed | mm/s | ________________ |
| Travel overhead | % | ________________ |
| Pass count | passes | ________________ |
Results
| Output | Unit | Recorded result |
|---|---|---|
| Scan lines per pass | lines | ________________ |
| Ideal scan distance | m | ________________ |
| Estimated scan duration | minutes | ________________ |
Sample check
Time a small representative engraving, then tune the overhead percentage against the machine’s actual behavior.
What I measured or tested: __________________________________________________
What changed after the test: __________________________________________________
Final decision: ______________________________________________________________
Use your browser’s Print command to print this page or save it as a PDF. For a filled worksheet, return to the calculator and choose Print result.